Online Learning Academy - LearnAcad.com

... Sharing Knowledge

  • Increase font size
  • Default font size
  • Decrease font size
Home

How to Recover Password of Cisco 2600 and 2800 Series Routers?

E-mail Print PDF

Follow these steps in order to recover your password:

  1. Attach a terminal or PC with terminal emulation to the console port of the router.

    Use these terminal settings:

    • 9600 baud rate
    • No parity
    • 8 data bits
    • 1 stop bit
    • No flow control
  2. If you can access the router, type show version at the prompt, and record the configuration register setting. Use the power switch in order to turn off the router, and then turn the router back on.
  3. Press Break on the terminal keyboard within 60 seconds of power up in order to put the router into ROMMON. If the break sequence does not work try CTRL + Break
  4. Type confreg 0x2142 at the rommon 1> prompt in order to boot from Flash. This step bypasses the startup configuration where the passwords are stored.
  5. Type reset at the rommon 2> prompt. The router reboots, but ignores the saved configuration.
  6. Type no after each setup question, or press Ctrl-C in order to skip the initial setup procedure.
  7. Type enable at the Router> prompt. You are in enable mode and should see the Router# prompt.
  8. Type configure memory or copy startup-config running-config in order to copy the nonvolatile RAM (NVRAM) into memory.
    Important: Do not type copy running-config startup-config or write. These commands erase your startup configuration.
  9. Type show running-config .
    The show running-config command shows the configuration of the router. In this configuration, the shutdown command appears under all interfaces, which indicates all interfaces are currently shut down. In addition, the passwords (enable password, enable secret, vty, console passwords) are in either an encrypted or unencrypted format. You can reuse unencrypted passwords. You must change encrypted passwords to a new password.
  10. Type configure terminal . The hostname(config)# prompt appears.
  11. Type enable secret in order to change the enable secret password. For example: hostname(config)#enable secret cisco
  12. Issue the no shutdown command on every interface that you use. If you issue a show ip interface brief command, every interface that you want to use should display up up.
  13. Type config-register . Where configuration_register_setting is either the value you recorded in step 2 or 0x2102 . For example: hostname(config)#config-register 0x2102
  14. Press Ctrl-z or end in order to leave the configuration mode. The hostname# prompt appears.
  15. Type write memory or copy running-config startup-config in order to commit the changes

Reference: http://www.cisco.com/en/US/products/hw/routers/ps259/products_password_recovery09186a0080094675.shtml

 

Last Updated on Thursday, 29 July 2010 09:27  
Follow us on Twitter

Main Menu

Linux

Islam

Windows

Interview Questions

Database

Internet

Cisco

Entertainment

Networking

Graduate Courses

Psychology

Feed Burner

Subscribe to Welcome to Online Learning Academy by Email

Enter your email address:

Delivered by FeedBurner


Google Groups
Subscribe to LearnAcad
Email:
Visit this group

Login Form